ASSEMBLY
1. Familiarize yourself with the jack.
Lifting Arm
Pump Plunger
2. Prior to assembly, carefully remove the stopper
attached to the handle socket. CAUTION: The
socket will tend to spring upward when the
stopper is removed. To prevent possible injury,
place one hand on the top of handle socket to
control the upward motion of the handle socket
, and then carefully remove the stopper. After
removed slowly allow handle socket to rise back
into resting position.
WARNING!
Once retaining stopper is removed, SLOWLY
allow handle socket to rise back into resting
position. Use CAUTION when removing retaining
clip, handle socket will spring forward rapidly.
All manuals and user guides at all-guides.com
Saddle
Front Wheel
Handle
Rear Swivel
Casters
Oil Fill Plug
Stopper
3. Refer to picture 2 when performing this step.
Press Quick Disconnect on handle piece 2, this
will allow slide handle pieces 1 and 2 connect,
align the holes on both sections to allow quick
disconnect to trigger. Quick disconnect will
automatically pop out when hole position is
correct.
Handle
PC. 1
4. Unfasten the screw located in the Handle Socket
to insert the assembled handle.
5. Line up the square whole located at the bottom of
the handle over the square bolt inside the Handle
Socket. (SEE IMAGE STEP 6)
6. Secure the handle in place by tightening the
screw in the Handle Socket Without any vehicle
on the jack. Cycle the lift up and down several
times to insure the hydraulic system is operating
properly. (Perform to the Air Purge Procedure
before first use.)
WARNING: Do not lift or carry jack by handle.
Handle could dislodge and jack may fall,
resulting in possible injury or property damage.
6
Handle
PC. 2
Quick
Disconnect
Handle Socket
Screw