Intended Use; Power Supply - Dolmar EM331 Manual De Instrucciones

ENGLISH (Original instructions)
SPECIFICATIONS
Model:
No load speed
Cutting height
Cutting width
Part number of replacement mower blade
Dimensions
(L x W x H)
Net weight
Safety class
• Due to our continuing program of research and development, the specifications herein are subject to change
without notice.
• Specifications may differ from country to country.
• The weight may differ depending on the attachment(s). The lightest and heaviest combination, according to
EPTA-Procedure 01/2014, are shown in the table.
Symbols
The followings show the symbols used for the equip-
ment. Be sure that you understand their meaning before
use.
Take particular care and attention.
Read the instruction manual.
DOUBLE INSULATION
Danger; be aware of thrown objects.
The distance between the tool and
bystanders must be at least 15 m.
Wait until all machine components have
completely stopped before touching them.
Keep the supply flexible cord away from
the cutting blades.
Beware of sharp blades. Blades continue
to rotate after the motor is switched off.
Remove the plug from the machine before
maintenance or if cord is damaged.
The noise of the machine is not more than
96 dB.
Keep hands and feet away. Do not operate
mower unless the guards and attachments
are in proper place.
During operation
(with grass basket)
When stored
(without grass basket)
EM331
20 mm - 55 mm
330 mm
YA00000731
L: 1,040 mm to 1,230 mm L: 1,140 mm to 1,330 mm
W: 380 mm
H: 870 mm to 1,110 mm H: 890 mm to 1,120 mm
350 mm x 380 mm x 335 mm x 415 mm x
1,090 mm
10.2 kg
Only for EU countries
Do not dispose of electric equipment
together with household waste material! In
observance of the European Directive, on
Waste Electric and Electronic Equipment
and its implementation in accordance with
national law, electric equipment that have
reached the end of their life must be col-
lected separately and returned to an envi-
ronmentally compatible recycling facility.

Intended use

The machine is intended for lawn mowing. Do not use
the machine for other purposes. Use of the machine for
operations other than the intended use could result in a
hazardous situation.

Power supply

The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated and can, therefore, also be used
from sockets without earth wire.
If the supply cord is damaged, it must be replaced by the
manufacturer or its service agent in order to avoid a hazard.
For public low-voltage distribution
systems of between 220 V and 250 V
Switching operations of electric apparatus cause volt-
age fluctuations. The operation of this device under
unfavorable mains conditions can have adverse effects
to the operation of other equipment. With a mains
impedance equal or less than 0.425 Ohms (for EM371)
or 0.427 Ohms (for EM410), it can be presumed that
there will be no negative effects. The mains socket used
for this device must be protected with a fuse or protec-
tive circuit breaker having slow tripping characteristics.
9 ENGLISH
EM371 EM410
-1
3,400 min
20 mm - 75 mm
370 mm 410 mm
YA00000732 YA00000733
L: 1,255 mm to 1,470 mm
W: 415 mm W: 460 mm
H: 955 mm to 1,230 mm
395 mm x 460 mm x
1,090 mm 1,220 mm
11.6 kg 14.5 kg
/II