ADDITIONAL GAS DRYER WARNINGS
For your safety, the information in this manual must be followed to minimize the risk of fire or explosion
WARNING
or to prevent damage, personal injury, or death.
- DO NOT store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance.
- WHAT TO DO IF YOU SMELL GAS:
-
California Safe Drinking Water and Toxic Enforcement Act
This act requires the governor of California to publish a list of substances known to the state to cause cancer, birth defects or other
reproductive harm and requires businesses to warn customers of potential exposure to such substances.
Gas appliances can cause minor exposure to four of these substances, namely benzene, carbon monoxide, formaldehyde and
soot, caused primarily by the incomplete combustion of natural gas or LP fuels.
Properly adjusted dryers will minimize incomplete combustion. Exposure to these substances can be minimized further by properly
venting the dryer to the outdoors.
PROPER INSTALLATION
This dryer must be properly installed and located in accordance with the Installation Instructions before it is
used. If you did not receive an Installation Instructions, you can receive one by visiting GEAppliances.com or
by calling 800.GE.CARES (800.432.2737).
Properly ground dryer to conform with all governing codes
and ordinances. Follow details in Installation Instructions.
Install or store where it will not be exposed to
temperatures below freezing or exposed to the weather.
Connect to a properly rated, protected and sized power
supply circuit to avoid electrical overload.
Remove all sharp packing items and dispose of all shipping
materials properly.
Remove the colored protective tape from the control
panel.
Do not obstruct the flow of ventilating air. Do not stack or
place laundry or throw rugs against the front or back of
the dryer.
Parts and Accessories
Order on-line at GEApplianceParts.com today, 24 hours
a day or by phone at 800.626.2002 during normal
business hours.
Part Number
Accessory
PM14X10056
Dryer door opening vent brush
(not included)
WX14X10007
LintEater™ Dryer rotary tube brush
(not included)
DR07X10002
6' Cable
DRM2E300V0
ACM, Splitter, two 6' Cables & a 1' Cable
All manuals and user guides at all-guides.com
Exhaust/Ducting:
All dryers MUST be exhausted to the outside to prevent
1
large amounts of moisture and lint from being blown
into the room.
Use only rigid metal 4 diameter ductwork inside the
2
dryer cabinet and use only rigid metal 4 diameter or UL
approved transition ducting between the dryer and the
home duct. USE OF PLASTIC OR OTHER COMBUSTIBLE
DUCTWORK CAN CAUSE A FIRE. PUNCTURED
DUCTWORK CAN CAUSE A FIRE IF IT COLLAPSES OR
BECOMES OTHERWISE RESTRICTED IN USE OR DURING
INSTALLATION.
For complete details, follow the Installation Instructions.
SAVE THESE INSTRUCTIONS
GEAppliances.com
3