Publicidad
Idiomas disponibles
Idiomas disponibles
Operating instructions
Settings
E
Individual settings for Timed Dry cycle minutes (Time), dryness level (Level), and temperature (Temp) can be set from
the minimum (lowest in column) to maximum (highest in column). In general, the higher up the column, the more
energy will be used.
-Selection
Time
only for Timed cycles.
-Selection only used for
Dryness Level
More Dry
Dry
Less Dry
Damp
Temperature
High
Medium
Low
Extra Low
Options
F
Delay Dry
As the Delay Dry button is repeatedly pressed, the delay time sets to from 1 to 9 hours, and back to clear (0). After selecting
the delay time, press Start and the delay time will count down the time remaining until the cycle starts.
If the Delay Dry button is pressed for 3 seconds, it clears (regardless of the delay time) or terminates a delaying cycle.
Extended Tumble
Use this option to minimize the wrinkles in clothes. It provides 1 hour of no-heat tumbling after the clothes are dry. If you are
using the cycle Signal and you select the Extended Tumble option, a signal will sound at the end of the drying time and every
5 minutes during the Extended Tumble cycle. This will remind you that it is time to remove the clothes.
eDry
Available for
When the eDry button is pressed, cycle settings change to reduce the total energy consumption of the selected sensor cycle.
NOTE: Cycle times will change when eDry is selected.
The eMonitor lights display the relative energy use of your selected cycle and options. They are provided as an energy guide
and range from Good (1 light) to Better (5 lights). Cycle (time), dryness level, temperature, and additional tumble options can
increase or decrease your energy efficiency. Some special cycles will not provide a display.
More Options
G
Drum Light
The drum light will go on if the Drum Light button is pushed or the door is opened. It will stay on until the door is shut or the
Drum Light or Power button is pushed.
Signal
Use the Signal button to change the volume of the end of cycle and control signals. Press the button until you reach the
desired volume (low-med-high) or off. The clothes should be removed when the beeper goes off so wrinkles do not set in.
NOTE:
Remove garments promptly at the sound of signal. Place clothes on hangers so wrinkles will not set in.
Use the Signal especially when drying fabrics like polyester, knits and permanent press. These fabrics should be removed so
wrinkles will not set in.
Control Lock
You can lock the controls to prevent any selections from being made. Or you can lock the controls after you have started a
cycle. Children cannot accidentally start the dryer by touching buttons with this option selected.
icon will light up when locked.
NOTE: The Power button can still be used when the machine is locked.
6
All manuals and user guides at all-guides.com
Each "setting" allows you to specify a lower (1 tap) or an upper (2 taps) time working your way from a
minimum 10 minute to a maximum 99 minute dry time (10, 20, 30, 40, . . . 80, 90, 99, 10 . . .)
Sensor cycles. Timed cycles run for the selected time.
Use for heavy-duty or mixed type fabrics.
Use for a normal dryness level suitable for most loads. This is the preferred cycle for energy savings.
Use for lighter fabrics.
For leaving items partially damp.
For regular to heavy cottons.
For synthetics, blends, delicates and items labeled permanent press.
For delicates, synthetics and items labeled tumble dry low.
For delicates, synthetics and items labeled tumble dry low.
press and hold the Drum Light and Signal buttons at the same time for 3 seconds. The control lock
press and hold the Drum Light and Signal buttons at the same time for 3 seconds.
and
.
Publicidad
