Descargar Imprimir esta página

HoMedics BMSC-4600H-EU Manual Del Usuario página 3

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 8
PRODUCT FEATURES:
1
2
3
4
INSTRUCTIONS FOR USE:
IMPORTANT - Preparing the appliance for use
The Shiatsu Massager comes with 2 screws located on the back of the unit to
protect the massage mechanism during shipment, which must be removed
before the first use to allow the shiatsu feature to function. Use the provided
Allen key. Then, properly dispose of the screws.
WARNING – Failure to remove screws may cause permanent damage to
the appliance.
NOTE: complete steps 1 and 3 before switching the appliance on at the mains.
1. Attach the Massage seat to almost any chair using the integrated strap
located at the back of the cushion. Ensure it is held firmly in place by
adjusting the strap as necessary.
2. Connect the power supply lead into a 220-240V mains outlet.
3. Once seated, use the remote control to operate the appliance. Press the
q button to activate the control and select one of massage types detailed
below.
4. For a gentler massage place a towel between your back and the massager.
5. Press the q button to stop the massage. The LED will blink while the
massage mechanism returns to the starting point before switching off.
Demo mode
To sample the neck and back Shiatsu massage, press Demo button to cycle
through all massage modes.
1 Demo Button
2 Neck Massage – 1 Clockwise
2 Anticlockwise
5
3 Neck height adjust – (press and hold to adjust)
4 Back Shiatsu –
Full Back
Upper Back
Lower Back
5 Power button
6 Back heat – Press to activate/deactivate on back only
4
6
Moving Shiatsu
massage mechanism
Shiatsu Neck Massage:
1. To turn on the massage on the neck, simply press the Neck Shiatsu button and
the LED light will illuminate.
Press once for clockwise action and twice for anti-clockwise
2. To deselect, press the button again.
3. Use the Up
or Down
specific areas.
Shiatsu Back Massage:
1.
: pressing this button gives a full Shiatsu massage up and down the back.
2.
: pressing this button gives a Shiatsu massage focusing on the mid to
upper back.
3.
: pressing this button gives a Shiatsu massage focusing on the mid to
lower back.
4. Press Heat
button once to add soothing heat and again to deactivate heat
mode.
5. To revert to standard massage mode, reselect one of the 3 massage zone
buttons.
NOTE: There is a 15 minute auto shut-off on this appliance for your safety. This
feature should not be considered as a substitute for 'OFF'. Always remember to
switch the appliance off when not in use.
3
to adjust the height to fit your neck and target

Publicidad

loading