TECshow NAVIGATOR NODE 8 MKII Manual De Usuario página 6

Set DMX port
Enter into the main menu by press MENU button,
then pressing UP / DOWN to choose the DMX port
X option and then press the ENTER to confirm your
selection. Then you can set the parameter of the
each port by pressing the ENTER and UP/DOWN.
Set DMX Port X parameters
Set Device ID
Enter into the main menu by press MENU button,
then pressing UP / DOWN to choose the Set Device
ID option, then press the ENTER to confirm your
selection. Press the ID No. (for example: 001) and
press the ENTER to enter and press UP and DOWN
to choose the ID No. for the unit from 000 to 255.
The ID is only used to recognize each of the unit
easily.
P. 6
Tecshow Navigator Node 8 MKII | English version
Disp Type Decimalism or hexadecimal system
DMX Status Input, output, disable
Normal input,
Backup input,
DMX Mode Single universe data-out,
Two universe data HTP-out,
Two universe data LTP-out
Protocol ArtNet, sACN(E1.31), KlingNet
Framerte/fs Data out rate:10~40 f/s
Network Set the DMX network parameters
Sub Network Set the DMX sub network parameters
Principal Set the first universe parameters
Secondary Set the second universe parameters
Resend Resend universe parameters
Pixel Type RGB, RGBW, RGBA, RGBD, RGBAW
Pixel Width Set the pixel width
Pixel Height Set the pixel height
Device ID
011
Cancel Enter