Set Display; User Preset - TECshow NAVIGATOR NODE 8 MKII Manual De Usuario

Set LCD Backlight
Enter into the main menu by press MENU button,
then pressing UP / DOWN to choose the Set LCD
Backlight option and then press the ENTER to
confirm your selection. You can choose its status
as ON/OFF. "ON" means the LCD backlight will turn
on all the time. "OFF" means the LCD backlight will
turn off automatically after idle 30 seconds.

Set Display

Enter into the main menu by press MENU button,
then pressing UP / DOWN to choose the Set Display
option and then press the ENTER to confirm your
selection. If you choose Inversion, the words will
display inversely.

User Preset

Enter into the main menu by press MENU button,
then pressing UP / DOWN to choose the User Preset
option and then press the ENTER to confirm your
selection. This setting help you easily use the appli-
cation avoid complicated setup procedure. You can
simply choose you desired mode by pressing UP
and DOWN.
User Preset
1. 8 X Input
2. DMX Split 1-7
3. DMX Split 1-3
4. DMX Clone
5. Isolated mode
LCD BlackLight
LCD Display
Normal
1. 8 x Input: Make the 8 DMX port as Input status.
2. DMX Split 1-7: This setting will help you make
the unit as one splitter which with one DMX
input to 7 DMX output. Please note that the LED
indicator of the DMX Output port will light up in
green.
3. DMX Split 1-3: This setting will help you make
the unit as one splitter which with one DMX
input to 3 DMX output. Please note that the LED
indicator of the DMX Output port will light up in
green.
4. DMX Clone: Direct through mode, the preset is
used to replicate a standard DMX signal from 4
(1-4) Input ports to 4(5-8) output ports.
5. Isolated Mode: Set eight ports as output.
1. ON
2. OFF
Inversion
| Tecshow Node 8 MKII
English version
P. 7