AL-KO 4712SP-A Manual Del Usuario página 24

GB
Initial startup
Caution!
The equipment should not be used if the cutting
gear and/or fastenings are loose, damaged or
worn.
Carry out a visual inspection before each start-
up.
The camera symbol on the following page refers
to the illustrations on Page 4–7.
Adjusting the cutting height
Caution - Risk of injury!
Adjust the cutting height only with the motor
switched off and when the mower blade has
come to a standstill.
▪ Always set all the wheels to the same cutting
height.
▪ Cutting height adjustment depends on the
particular model.
Axle adjustment or central adjustment (
1. To release the lever, press to the side and hold.
2. Push the lever to the left or right to select the
desired cutting height.
3. Let the lever click into position.
4. Check that all wheels are set to the same position.
Quick adjustment of individual wheels
or axle adjustment (
1. To release the lever, press to the side and hold.
2. Push the lever to the left or right to select the
desired cutting height.
3. Let the lever click into position.
4. Check that all wheels are set to the same position.
22
1, 2)
3)
Central axle adjustment
1. Place a thumb at each end of the axle.
2. Place the fingers under the mower housing.
3. Using both thumbs, press the axle out of its present
height setting notch.
4. Using both thumbs, push the axle to the desired
height setting notch, then allow it to engage.
5. Check that all wheels are set to the same position.
Mowing with the grass catcher
Caution - Risk of injury!
Attach/detach the grass catcher only when the
motor is switched off and the mower blade has
come to a standstill.
6. Lift the deflector plate and insert the grass catcher
6).
in the holders (
Important!
Only a correctly attached and undamaged grass
collector offers sufficient protection against flying
objects!
Fill level indicator
The fill level indicator is pushed upward by the air flow
5a).
when mowing (
If the grass catcher is full, the indicator points to the box
( 5b). The grass catcher must be emptied.
Emptying the grass catcher
1. Lift the deflector plate.
2. Unhook the grass catcher and pull backward to
6).
remove (
3. Empty the grass catcher.
4. Lift the deflector plate and insert the grass catcher
in the holders ( 6).
Translation of original user instructions
Petrol lawnmower
4)
(