Eaton U442-DOCK4-S Manual Del Usuario página 5

Installation
Notes:
1) Supports the connection of three monitors at the same time through DisplayPort MST Mode.*
2) To ensure proper function of the five USB (4 USB-A and 1 USB-C) hub ports, make sure to plug
in the included external power supply or the host device's PD charging power supply to the unit.
3) When the included 72W power adapter is connected to the DC port, it supplies power to charge
the host PC first (up to 60W) with the rest of the power being supplied to the dock.
4) When the PD charging power adapter is connected, 15W of total power will be reserved first to
guarantee the functioning of the product. The rest of the power will be used to charge the host
PC (the power that the host PC can get depends on the result of PD protocol negotiation).
5) When the DC port is connected prior to the Type-C PD Charging port, the docking and host PC
are powered from the DC port, with the Type-C port as an alternative power source.
6) When the Type-C PD Charging port is connected (with a PD power adapter) prior to the DC port,
the docking and host PC are powered from the Type-C port with the DC port as an alternative
power source.
7) If the active power source (power source that is supplying power) is unplugged, the alternative
power port will be switched on automatically to be the active power source. In this case, the
connected devices will get disconnected for a few seconds and then reconnect automatically.
8) See Optional Accessories section for suggested cables.
9) When the unit is connected to the USB-C port on your computer and to a network via Cat5e/6
cabling, a network connection will be automatically established. If no connection is made, you
can manually establish one by going to your computer's network settings page. For example, on a
Mac, you would navigate to the Network section found in System Preferences, click the "Assist Me"
button to get to the Network Setup Assistant, then follow the prompts to establish a connection.
* See Multi-Monitor Requirements section for details.
1. Connect the included power supply between the unit and a power source and/or the
included USB Type-C cable between the unit and a PD charging adapter (not included).
Note: The USB hub ports may go into overcurrent protection if high-powered USB peripherals
are attached without the external power adapter being connected. The USB Type-C PD Charging
port can also be used for data transfer.
2. Connect a USB Type-C enabled laptop or computer to the unit's USB Type-C host port
using a USB Type-C cable.
3. Connect a 3.5 mm Mini Stereo cable to the back of the unit to connect a speaker.
4. Connect up to four USB devices to the dock's USB-A hub ports.
5. Connect the adapter's RJ45 port to a network using a UTP cable.
6. Connect the dock's VGA port to the VGA port on a monitor using a VGA cable.
OR
7. Connect the dock's HDMI port to the HDMI port on a monitor using a HDMI cable.
OR
8. Connect the dock's DisplayPort port to the DisplayPort port on a monitor using a
HDMI cable.
9. Connect a 3.5 mm Mini Stereo cable to the front of the unit to connect a microphone
or headphones.
21-03-270-933DBD.indb 5 21-03-270-933DBD.indb 5
5
7/27/2021 10:08:01 AM 7/27/2021 10:08:01 AM