Manual mode
Use the manual mode to prepare any amount of coff ee without a set preparation time. Press the manual mode button
to
start preparing coff ee. When the required amount of coff ee is prepared in the cup, press the manual button
again and the
preparation will end.
Milk froth preparation
IMPORTANT NOTICE: Before preparing milk froth, fi rst prepare the coff ee for which the milk froth will be made. Leave the
metal lever and fi lter with spent coff ee in the coff ee machine during milk froth preparation.
Press the button for hot steam preparation
; the blue indicator lamp will begin to fl ash and the coff ee machine will begin to be
heated. When the indicator lamp ceases to fl ash, the coff ee machine has reached the operating temperature for preparing milk froth.
Place the steam nozzle into the empty taller vessel and briefl y rotate the hot steam control counter-clockwise until all remaining
water leaves the nozzle. When steam begins to escape from the nozzle, turn the control to the OFF position to discontinue
steam dispensing. Put the required amount of cooled semi-skimmed or whole milk into the taller vessel that is suitable for
preparing milk froth. Submerge the end of the steam nozzle in the centre of the milk and rotate the hot steam control to the
position for dispensing hot steam
. Hot steam will begin to fl ow from the nozzle into the milk, the milk will begin to whirl and
11
froth
. Slightly incline the vessel so that the end of the steam nozzle is just below the milk level during the entire time of milk
froth preparation. When the milk is frothy enough, lift the vessel so that the steam nozzle is submerged deeper in the milk froth,
set the control to the OFF position and end milk froth preparation. If there are too large bubbles in the prepared milk froth, disrupt
them by tapping the vessel on a fl at pad. To stir the remaining milk accumulated at the bottom of the vessel with milk froth, shake
the vessel horizontally. Before preparing coff ee or hot water immediately after preparing milk froth, wait for at least 10 minutes
until the machine cools down to the temperature for preparing coff ee or hot water.
Useful hint: If you do not want to wait, run the "Hot water preparation" mode (see below) and allow all hot steam to leave the steam
nozzle. You can prepare coff ee or hot water after the hot steam has ceased to fl ow out of the steam nozzle and is replaced by hot water
(after about 20 seconds).
Hot water preparation
To prepare hot water, direct the end of the steam nozzle to the taller vessel. Press the manual mode button
and immediately
12
afterwards rotate the control to the position for preparing hot steam
. Hot water will begin to fl ow out of the steam nozzle
.
When the required amount of hot water is in the vessel, press the manual mode button and rotate the control to the OFF position
to end hot water preparation.
Switching off the coff ee machine
To switch off the coff ee machine, press the switch on/off button
and the coff ee machine will switch off . If you do not switch off
the coff ee machine manually and do not use it for 30 minutes, it will switch off automatically.
Decalcifying
Decalcify the coff ee machine every 2 to 3 months. Use a high-quality agent for coff ee machines. Fill the water reservoir to the MAX
mark with a mixture prepared following the instructions for the cleaning agent. Switch on the coff ee machine, press the manual
mode button
and allow the entire mixture from the reservoir to run through the coff ee machine, with the lever attached
13
and an empty fi lter, into a prepared vessel
. When all water from the reservoir has been pumped (the pump sound changes),
immediately press the manual mode button
and end decalcifi cation.
Notice: Regularly decalcify also the steam nozzle using the hot water mode.
Post-decalcifi cation cleaning
After each decalcifi cation, rinse the parts inside the coff ee machine with clean water, with the lever attached and an empty fi lter.
Pour clean water into the reservoir to the MAX mark, press the manual mode button
and allow the clean water to run through
the coff ee machine. When the water level in the reservoir reaches the MIN mark, press the manual mode button again
to end
the post-decalcifi cation cleaning of the coff ee machine. Rinse the reservoir under running water, fi ll to the MAX mark and place
back into the coff ee machine.
Cleaning the fi lters and the lever
After use, remove the spent coff ee from the lever with fi lter and clean both. Remove the lever from the coff ee machine, fold and
14
press the lock for removing spent coff ee
and remove the spent coff ee from the fi lter by tapping the lever on an edge or using
15
a suitable object
. Release the lock, remove the fi lter, wash both parts under running water and dry.
6