Publicidad
Idiomas disponibles
Idiomas disponibles
Al transformador
Marking line
3: 1) Remove the cabinet from the marked locations and enlarge the new holes accordingly for the wall anchors (B) (not included - if
applicable). 2) Insert the wall anchors into the new holes.
4: To hang the cabinet, insert (x 2) of the 2" screws provided with washers through the drilled holes directly into the wall. Figure 1.
5: Attach the knob by using (x 1) of the 1" screws provided. Figure 1.
6: 1) Place the mirror in position on the wall aligned with the left cabinet and mark the hanging hole locations. 2) Remove the mirror
and drill 2 holes in the wall according to the hole positions marked. It is recommended that you use wall anchors (B) (not included) to
secure your mirror. 3) Insert the wall anchors (if applicable) into the new holes. 4) Insert (x 2) of the 2" screws provided through the
drilled holes/anchors directly into the wall. Figure 2.
Marking line
Figure 5
7: 1) Determine the location for the right side wall cabinet (aligned with the left cabinet and mirror). 2) Repeat steps 1 through 5 to hang
the right side cabinet. Figure 3.
8: Hang the mirror on the wall with the provided hanging hardware attached to the back of the mirror. Figure 4.
9: 1) Position the valance above the unit, aligned on all edges. 2) Carefully lower the valance and attach it to the tops of the wall
cabinets (on both left and right cabinet) using the 1-1/4" screws and washers provided. Figure 5.
10: 1) Insert each light wire through each valance hole from the bottom (the light transformer and wires will sit on top of the valance).
Figure 6. 2) Insert each light into each valance hole from the bottom. Figure 7. 3) Connect each light connector (socket) with its
respecting adapters and then connect to the power supply. Figure 8.
A las luces
Marking line
LED light
wires
Mirror
B
Figure 2
Figure 3
Socket
Figure 6
Figure 4
Socket
Figure 7
Mirror
LED light
Publicidad
