Tristar HD-2382 BLOWN Manual De Usuario página 8

eN iNstruc tioN maNuaL
electricity. This RCD must have a rated residual operating current no
higher than 30mA. Ask your installer for advice.
• This appliance is not intended for use by person (including children)
with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision
or instruction concerning use of appliance by a person responsible for
their safety.
• Children should be supervised to ensure that they do not play with the
appliance.
• If the supply cord is damaged, it must be replaced by manufacturer, its
service agent or similarly qualified persons in order to avoid a hazard.
• Do not use this appliances in the bathroom or near a sink filled with
water. If this appliances has fallen into the water do not under no
circumstances directly grab this appliances but first pull the plug from
the socket.
• When the hairdryer is used in a bathroom, unplug it after use since
the proximity of water presents a hazard even when the hairdryer is
switched off:
• For additional protection, the installation of a residual current device
(RCD) having a rated residual operation current not exceeding 30mA
is advisable in the electrical circuit supplying the bathroom. Ask your
installer for advice.
• This hair dryer if it can be fitted on the wall then it should be fitted
away and out of reach of persons who are taking a bath or washing
themselves.
(*) C ompetent qualified electrician: after sales department of the producer
or importer or any person who is qualified, approved and competent to
8
perform this kind of repairs in order to avoid all danger. In any case you
should return the appliance to this electrician.
before the first use
• Take the appliance and accessories out the box. Remove the
stickers, protective foil or plastic from the device.
• Clean before use the appliance with a damp cloth.
• During first use there could be some smoke and a burning smell. This
happens because the appliance is new. It will disappear after a few minutes.
This does not mean there is a malfunction and it will not cause one.
use
• Unwind the power cord and insert the plug into the socket.
• Put on the desired accessory, you can choose between the concentrator,
half brush, roll brush, big point roll brush or the big half brush.
• Adjust the heat level with the heat switch.
• Adjust the blowing level with the power switch.
• By pressing the cold shot button it is possible to interrupt the heating
process so that the air can be mixed according to individual requirements.
• Switch off the dryer and remove the power cord out of the socket.
• Allow the appliance to cool down.
changing at tachments
• Important: the element of the appliance will become very hot when
plugged in and switch on. Before fixing or removing any attachments,
ensure the appliance is cool , switch of and is unplugged.
• Line up the imprinted arrow on the attachment with the release button.
• Push the attachment onto the hot air styler until you hear it click into place.