Jimmy HW10 Instrucciones De Uso página 8

Machine charging
Connect the adapter to the power supply, put the
upright vacuum cleaner into the charging base to
start charging.(Fig20)
Note:
1. Before the first use, please fully charge the battery
pack, and before the second charge, please empty the
battery to ensure the life of the battery pack;
2. If the product is to be long idled, please charge it
once every three months;
3. When not charging, please remove the adapter from
the socket to prevent the danger of accidental touching.
Brushroll air-drying function
In the charging mode, press and hold the handle
mode button for 3 seconds to enter the brushroll
air-drying mode for 4 hours. During the air-drying
process, the decorative light is on, and the
brushroll will rotate slightly at intervals to adjust
the air-drying position; Press again mode button
to turn off the drying mode.
Note:This mode is designed to prevent humid brushroll
from breeding bacteria or odors. (The display is shown
in Fig21)
Brushroll & air path self-cleaning
function
In the charging mode, press the self-cleaning button to enter the cleaning mode (The display is
shown in Fig22).After the self-cleaning is completed, the machine enters brushroll air-drying mode
and returns to the charging mode; during the self-cleaning process, to end the self-cleaning mode in
advance , press on/off button and machine will return to charging mode.
Note:
1. Self clean mode is only to clean floorhead air path and hardfloor brushroll. Do not run self clean on the carpet
brushroll.
2. Before turning on the self clean mode, please empty dirty water in the dirty water tank first, check that the
machine has been firmly placed on the charging stand, the adapter is plugged into the socket and connected
to the charging stand. The clean water tank retains at least 1/2 water volume; After completing self cleaning,
please clean the dirty water tank again.
3. When the battery is less than or equal to 10% power, the self-cleaning mode cannot be turned on, and it can
be turned on normally after charging for a period of time.
Clean water tank empty indicator
When using the water spray function, the voice/screen shows "No clean water, fill in water" (Fig
23 and Fig24 alternately display), please turn off the machine and add water to the clean water
tank.When using the clea self clean mode, if it is detected that there is no water in the clean
water tank, the brushroll self cleaning will be stopped. To continue self cleaning, please add
water to the clean water tank and empty the dirty water tank, then restart self clean mode.
Note:When adding clean water, you can add the equipped JIMMY cleaning solution, the ratio is about 1 bottle
cap of cleaning solution to one full water tank, the water temperature cannot exceed 40°C.
Fill up clean water tank: After removing the clean water tank, open the water filling plug, turn it to the
side to expose the water inlet hole, pour clean water and cleaning solution in, and then plug back to
the original position and reinstall the clean water tank to floorhead. (Fig25)
6
20
22
24
21
23
25
Water filling
plug
Clean water tank