Publicidad
Idiomas disponibles
Idiomas disponibles
EN
•
Inspect all operating parts before each use for signs of wear or damage. Any scratched,
cracked or pitted parts should be replaced immediately before using again to avoid
severe personal injury.
•
Check for light tightness before each use.
•
Select the shade number you require at the turn of shade knob. Finally be sure that the
shade number is the correct setting for your application.
•
Adjust headband so that the helmet is seated as low as possible on the head and close
to your face. Adjust helmet´s angle when in the lowered position by turning the
adjustable angle limitation washer.
•
Do not make any modifications to either the welding lens or helmet, other than those
specified in this manual. Do not use any replacement parts other than those specified in
this manual.
1.
PRODUCT FEATURES.
•
The auto-darkenning welding helmet PE-1000/3XL is of completely new design, with
Shell material high and low temperatura resistant. Corrosión resistance, flame
retardant, soft, light tight, intensity high and durable.
•
Clear visión on the work piece both prior and during welding, which means improved
quality and higher efficiency.
•
Overall process protection against ultraviolet (UV) and infrared (IR) radiation.
•
The PE-1000/3XL is equipped with lithium battery and solar cells that extends the life
of the battery.
WARNING: Failure to follow these warnings and/or failure to follow all of the operating
instructions could result in severe personal injury..
2.
OPERATING INSTRUCTIONS.
1.
Peel off the protective film inside and outside the surfaces of lens.
2.
Prior to welding, the filter screen is in a transparent and clear state, enabling a clear
vision on work piece, at the moment of starting welding, it automatically changes the
filter screen from clear to dark state. At the moment of stopping welding, the filter
screen automatically changes from dark to clear state.
3.
Adjust the operation mode to Welding or Grinding. While operating in Grinding mode,
the filter do not react to welding arc and keeps clear.
4.
Adjust the shade number knob according to different welding current and welding
process to select proper shade number. See table 1.
5.
To adjust the sensibility level stop welding and adjust the sensibility to higher till filter
flashes. Adjust the sensibility level a Little lower them.
6.
Adjust the delay time. Delay time feature the time the len turn from dark to clear state
after stopping welding.
7.
Adjust the headgear. See figures a, b, c, and d.
23
Publicidad
