ROTOR Gastronom GT95 Manual De Instrucciones página 17

CH-3661 Uetendorf
Mix
- Insert the container into the retaining ring on the motor base, taking care to keep it
vertical.
- Add ingredients to be mixed.
- Place the lid in such a way, that the hole in the tab at the lid sticks over the end of the
rod, that the lid is firmly closed.
- Switch on motor and vary the speed according to the ingredients being mixed, turn the
speed control knob clockwise until the desired speed is reached. The maximum speed
is reached at position 8.
Particularly in the case of thick, viscous materials, the highest possible speed should be
selected so that the motor is not heated up unnecessarily.
Liquids and fine grained materials can be added through the filler opening in the lid of the
container during operation (Remove the lid lock).
The motor only runs if the lid is in position!
By switching on and operating at high speed, it is recommended that the bowl should be
held (lay hand on the lid).
Never use the mixer without lid!
To avoid heavy injuries or damages of the appliance, it is
forbidden, while mixing to reach into the container with
hands or with a hard solid object. This is although valid by
a standing still motor and assembled container, in case of
unintentional switching. Do not reach into the container with
a hard solid object by opening the lid lock.
The mixer should never run without container. Do not touch,
nor with any other object, the rotating coupling piece on top
of the motorbase.
Never put a cutter assembly on the motor base without
the container (extremely dangerously)!
- Turn off: Turn the speed control knob counter clockwise to "0".
Container removal
First remove the complete container from the motor
base and empty it totally.
Attention: To loose the plastic threaded ring,
turn to the right. Clockwise, like closing
a water tap, as the threaded ring is
left-threaded!
Instruction Manual
Rotor Gastronom GT95
© Rotor Lips AG
OPEN
TURN
RING
15