Ironing Without Steam - Thulos TH-CP2250 Manual De Instrucciones

IRONING WITHOUT STEAM

• STEP 1: The water tank does not need to be filled In order to
iron without steam; if it ¡s full it can either be emptied or left so
that it is ready for the next use with steam.
• STEP 2: Plug in and rotate the temperature control in a
clockwise direction on iron.
• STEP 3: To increase the temperature, rotate the temperature
control dial in a clockwise direction until the required
temperature is selected. Reduce the temperature by rotating
the temperature control dial in an anticlockwise direction. The
temperature indicator light will illuminate to indicate that the
iron is heating up; this will switch off when it is ready to use.
• STEP 4: After use, rotate the temperature control dial to the
"MIN" position, then unplug from the main power supply.
VERTICAL STEAM IRONING
• STEP 1: Hang up the item to be vertically steamed.
• STEP 2: Fill the water tank according to the instructions in the
section entitled 'Filling the Water Tank".
• STEP 3: Rotate the temperature control dial to position 2 heat
setting. The higher the temperature the more powerful the
steam.
• STEP 4: Holding the iron approximately 20 cm away from the
item, press and hold the steam button or push the steam locker,
working in short bursts to remove any creases.