LIVARNO home 1115-S Instrucciones De Uso Y De Seguridad página 10

protective strip� Remove the strip to start
using the product�
z Operation
The product can be operated in three
different modes� These can be set using the
remote control �
10
Please note: The solar panel will turn the
product on in twilight or darkness in the
mode you have set�
Please note: Battery charging via the solar
panel does not depend on which mode is
selected� The battery is charged continuously
at all times�
Start by turning the product on by pressing
„ „
the ON/OFF button
Mode: Sensor mode
Press the "Sensor Mode" button on the
„ „
remote control (see Fig� A)�
10
If the motion sensor detects movement
„ „
within its range, the product will light up at
maximum brightness�
The LEDs will switch off if no new movement
„ „
is detected for 30 seconds�
When the LEDs are off and the motion
„ „
sensor is on standby, the signal LED
flash red (see Fig. A).
You can also toggle Sensor Mode by
„ „
pressing the ON/OFF button
Mode: Flash
Press the "Flash" button on the remote
„ „
control �
10
The LEDs will flash for approx. 30 seconds.
„ „
Finally, Sensor Mode will be activated (see
"Mode: Sensor Mode")�
10
US-EN
�
7
will
9
�
7
Mode: 75% - brightness
Press the "75%" button on the remote
„ „
control �
10
The product lights up with reduced
„ „
brightness� The motion sensor is inactive
in this mode�
Switching the product off
You can turn the product off using the
„ „
remote control by pressing the ON/OFF
button �
7
Please note: You can still control the
product using the remote control�
To do this, press the "Sensor Mode" button�
„ „
Alternatively, you can turn off the product
using the ON/OFF button�
z Changing the batteries
(remote control)
Opening the battery compartment of the
„ „
remote control �
10
Squeeze the tab and pull out the battery
„ „
compartment�
Remove the discharged battery and
„ „
dispose of it properly�
Insert a battery into the battery
„ „
compartment in line with its polarity (+/-)�
Push the battery compartment into the
„ „
remote control� Make sure that the battery
compartment is tightly sealed�
z Cleaning and Storage
Switch the product off if you want to stop
„ „
using it, store it away and/or clean it�
Regularly inspect the motion sensor
„ „
solar cell to make sure they are not
2
dirty� Remove any dirt to ensure proper
functioning of the product�
10
and
8