Publicidad
Idiomas disponibles
Idiomas disponibles
3.2. First commissioning
When switching on the electronics unit for the first time, carry out the following programming.
Flashing
Meaning
display
Pool volume to
be specified
5.0
(5.0 is the
default setting).
3.3. Keypad
COMMAND KEY
(depending on
model)
Switching on the electronics unit.
Switching off the electronics unit (press and hold).
MENU
Access the menus.
Boost mode starts for 24 hours.
BOOST
Display of the water temperature for a few seconds.
T°C
Direct access to the menu to adjust the temperature measurement (press and hold).
Display of the salt level for a few seconds.
SALT
Direct access to the menu to adjust the salt rate measurement (press and hold).
Display of pH measurement.
pH
Direct access to the menu to calibrate the pH probe (press and hold).
Selecting a value or data element.
Cancellation of an entry
Back to previous menu.
Stopping Boost mode.
Command confirmation.
Entering a menu.
OK
Dismissing an alarm.
3.4. LEDs
Colour
Green
Red
3.5. Screen
Display
by default
flashing
solid
OK ? OK ? OK
From 0.1 to 0.9 (i.e. from 1 to 9 m
From 1.0 to 9.5 (i.e. from 10 to 95 m
From 10 to 20 (i.e. from 100 to 200 m
A few minutes after switching on, production starts automatically.
When switching off, the screen and the green LED turn off while the red LED comes on.
If an alarm has been activated, press first on
Status
Continuously on
Continuously on
Flashing
pH
Possible settings
3
), in increments of 0.1.
3
), in increments of 0.5.
3
), in increments of 1.
FUNCTION
to switch off.
Production in progress
Electronics unit powered off, or wintering mode activated
Alarm activated
Meaning
Production setpoint (in %)
Information awaiting validation, or alarm activated
Information validated or read only
Setting confirmed, or successful operation
Failed setting or operation
Call to wait a few moments
Call to confirm an entry with the OK button
Peristaltic pump running
Select a value with
the
then confirm with
the OK button.
Meaning
Navigation
buttons,
4
Publicidad
