Descargar Imprimir esta página

Craftsman professional 247.88830 Manual Del Usuario página 10

Publicidad

Idiomas disponibles

Idiomas disponibles

7. Make sure all cables are routed to the left of the chute control rod.
Line up the hole in the hex end of chute rod with the arrow on the
input shaft and insert the hex end of the rod into the input shaft
below joystick on handle panel. See Figure 7.
NOTE: The chute rod will fit snuggly into the input shaft. Support the
rear of the dash panel with one hand while inserting the chute rod with
your other hand to ensure the chute rod is inserted
input shaft.
8. Now push the round end of chute rod back towards the handle
panel until the hole in the rod lines up with the hole in the chute
control input closest to the chute control head. Insert the cotter
pin. See Figure 8.
NOTE: The second hole is used to achieve further engagement of
the hex end of chute rod into the input shaft if required and can be
used later for adjustment if the chute does not fully rotate. Refer to the
Service & Maintenance section for Chute Control Rod adjustments.
9.
Finish securing chute control head to chute support bracket with
wing nut, and clevis pin and bow-tie cotter pin removed earlier. Do
not overtighten. See Figure 9.
ASSEMBLY
all the way
Figure 7
into the
10
Figure 8
Figure 9

Publicidad

loading

Este manual también es adecuado para:

247.88830131ah55th799