Altech CPS 130-4 Instrucciones De Montaje página 9

GB
SPEED REGULATOR – ELECTRONIC PUMPS
In order to guarantee efficient operation of the heating installation and optimum
adaptation of the pump to the load on the hydraulic installation, it is important
to select the right control range. The pump control channel is selected using a
3-stage selector switch (Fig 5b) in accordance with the installation requirements.
The pump operates within the chosen control range and adapts continuously to the
fluctuating power requirements of the installation, in particular when thermostatic
valves are used.
After switching to a different control range, it will take some time before the
heating installation control becomes stable.
6. MAINTENANCE
No routine maintenance is necessary, however, during prolonged shutdown e.g.
summer months, it is advisable to run the pump for a few minutes every few weeks.
7. TROUBLE SHOOTING GUIDE
FAULTS AND REMEDIES
PUMP FAILS TO START
Check power supply fuses.
Check voltage at pump terminals (see pump nameplate data).
Check electrical connection wiring procedure (see section 4.3).
Check rotor free to rotate (see section 5).
PUMP STARTS BUT PROVIDES INCORRECT CIRCULATION
Check pump case and system adequately vented (see section 5).
Check correct electrical regulator setting (see section 5).
8