Publicidad
Idiomas disponibles
Idiomas disponibles
3.
Carefully remove the belt from around the idler pulleys and the spindle pulleys.
Avoid pinching injuries. Never place your fingers on the idler spring or
between the belt and a pulley while removing the belt.
4.
Route the new belt as shown in Figure 37 for 42" Decks, Figure 38 for 46"
Decks and Figure 39 for 50" and 54" Decks.
SERVICE AND MAINTENANCE
Flange Lock Nut
Figure 36
WARNING
Figure 37
NOTE: Use a 3⁄8" drive ratchet wrench as instructed in earlier steps when
routing the new belt.
5.
Retighten idler pulleys.
6.
Remount the spindle covers if removed after step 1.
7.
Re-install the deck making sure the belt remains routed around the pulleys
as instructed.
28
Figure 38
Figure 39
Publicidad
