Publicidad
Idiomas disponibles
Idiomas disponibles
Downloaded from www.watergardeningdirect.com
- EN -
Safe operation
Do not carry or pull the unit by its electrical cable.
Route cables/hoses such that they are protected from damage and do not present a tripping hazard.
Only use original spare parts and accessories for the unit.
In the case of electrical units and installations with a rated voltage of U > 12 V AC or U >30 V DC located in the wa-
ter: Isolate the units and installations (switch off and disconnect from the power supply) before reaching into the wa-
ter.
Only operate the pump together with the supplied solar module.
Do not allow the pump to run dry.
Protect the unit from knocks or vibration.
Clean the unit at least twice a year.
Keep the connection plugs dry.
Installation and connection
How to proceed:
B
1. Assemble the nozzle unit and the LED lighting and fit onto the pump.
– Adapt the number of nozzle extensions used to the depth of the pond.
2. Connect the connection cables of the pump and LED lighting to the solar module. (→ Commissioning/start-up)
– Push each plug into the socket as far as possible to ensure that the connection is watertight.
3. Assemble the ground stake set and attach it to the solar module.
– Align the solar module such that the sockets with the connection cables point downwards.
4. Install the solar module so that it is exposed to direct sunlight.
– Recommendation: Align the solar module to the sun to ensure maximum energy yield.
5. Fix the pump underwater to a smooth, clean surface using the suction cups.
10
Publicidad
