7.2 Automatic setting according to the DCF signal
• After successful transmission of the indoor and outdoor
temperatures between the measuring and base stations, the
weather station (after around 3 minutes) automatically starts
searching for a DCF signal. During the search process, the DCF
radio signal (2) and display go dark. This can take a further
7 min.
• When the radio signal is received, the date and time are set
automatically.
Note - setting the time
• If no DCF radio signal is received within the first few minutes
of the initial setup procedure, the search is terminated. The
radio symbol disappears.
• In the event of reception problems, we recommend leaving
the clock standing overnight since the interference signals are
generally fewer in number at this time.
• Meanwhile, you can carry out a manual search for the DCF
radio signal at a different location or set the date and time
manually.
• The clock automatically continues to search for the DCF radio
signal daily (01:00, 02:00, 03:00, 04:00 and 05:00). Once
the signal is received successfully, the manually set time and
date are overwritten
If the weather station does not receive the DCF signal, press the
RCC button (F) at least 3 seconds to start the signal search again.
The radio symbol flashes during the search and the display goes
dark. If a signal is still not received after that, the time and date
must be set manually.
Note
Language and time zone are preset to Germany. You can find
instructions and information on making changes in our detailed
operating instructions at www.hama.com
8. Backlight
• In power unit mode, press the Snooze / Light button (29)
repeatedly to toggle between the 3 lighting stages (bright,
dimmed, off).
• In battery mode, press the Snooze / Light button (29) to
illuminate the display for around 10 seconds.
9. Care and maintenance
Note
Disconnect the device from the mains before cleaning and
during prolonged periods of non-use.
• Only clean this product using a lint-free, slightly damp cloth and
do not use any harsh cleaners.
• Ensure that no water is able to enter the product.
10. Warranty disclaimer
Hama GmbH & Co KG assumes no liability and provides no
warranty for damage resulting from improper installation/mounting,
improper use of the product or from failure to observe the operating
instructions and/or safety notes.
11. Technical data
Speci cations according to Regulation (EU)
2019/1782
Brand name, commercial register
number, address
Model identifier
Input voltage
Input AC frequency
Output voltage /
output current /
output power total
Average efficiency during
operation
Efficiency at low load (10%)
Power consumption at zero load
Hama, HRA12159,
Dresdner Str. 9, 86653
Monheim
HX075-0500600-AG-001
100-240 V
50 / 60 Hz
5.0 V DC
0.6A
3.0W
72.8%
59.1%
0.06W
7