Black and Decker LDX172C Manual De Instrucciones página 7

toRQue ContRol (figuRe C)
This tool is fitted with a torque adjustment
collar (3) to select the operating mode and
to set the torque for tightening screws. large
screws and hard workpiece materials require
a higher torque setting than small screws and
soft workpiece materials.
• For drilling in wood, metal and plastics, set
the collar to the drilling position symbol .
• For screwdriving, set the collar to the desired
setting. If you do not yet know the appropriate
setting, proceed as follows:
• Set the collar to the lowest torque
setting.
• Tighten the first screw.
• If the clutch ratchets before the desired result is achieved, increase the collar
setting and continue tightening the screw. repeat until you reach the correct
setting. Use this setting for the remaining screws.
keyleSS CHuCk (figuRe d)
WaRning:
Make certain the lock-off
button is engaged to prevent switch actuation
before installing or removing accessories.
To insert a drill bit or other accessory:
1. Grasp the rear half of the chuck (4)
with one hand and use your other
hand to rotate the front half (4a) in the
counterclockwise direction, as viewed from
the chuck end.
2. Insert the bit or other accessory fully into
the chuck, and tighten securely by holding
the rear half of the chuck and rotating the
front portion in the clockwise direction as
viewed from the chuck end.
WaRning:
Do not attempt to tighten drill bits (or any other accessory) by gripping the
front part of the chuck and turning the tool on. Damage to the chuck and personal injury
may occur when changing accessories.
SCReW dRiVing
For driving fasteners, the reversing button should be pushed to the left. Use reverse
(button pushed to the right) for removing fasteners. When moving from forward to reverse,
or vice versa, always release the trigger switch first.
on BoaRd Bit StoRage
A bit storage slot (6) is built-in to the area just above the battery pack.
dRilling
• Use sharp drill bits only.
• Support and secure work properly, as instructed in the Safety Instructions.
• Use appropriate and required safety equipment, as instructed in the Safety Instructions.
• Secure and maintain work area, as instructed in the Safety Instructions.
• Run the drill very slowly, using light pressure, until the hole is started enough to keep the
drill bit from slipping out of it.
• Apply pressure in a straight line with the bit. Use enough pressure to keep the bit biting
but not so much as to stall the motor or deflect the bit.
• Hold the drill firmly with two hands, one hand on the handle, and the other
gripping the bottom around the battery area.
• DO NOT CLICK THE TRIGGER OF A STALLED DRILL OFF AND ON IN AN ATTEMPT
TO STArT IT. DAMAGe TO THe DrIll CAN reSUlT.
• Minimize stalling on breakthrough by reducing pressure and slowly drilling through the
last part of the hole.
• Keep the motor running while pulling the bit out of a drilled hole. This will help reduce jamming.
• Make sure switch turns drill on and off.
C
3
d
4a
4
7