Publicidad
Idiomas disponibles
Idiomas disponibles
1. To set the saw for a bevel cut, raise the lever (L) or turn the knob
(O) to loosen the bevel adjustment.
2. Tilt the shoe to the desired angle by aligning the pointer with the
desired angle mark on the pivot bracket.
3. Retighten the bevel adjustment by lowering the lever or turning
the knob.
FIG. 8
DW367
O
Bevel Detent (Fig. 7, 8)
WARNING: To reduce the risk of serious personal injury,
turn tool off and disconnect tool from power source before
making any adjustments or removing/installing attachments or
accessories.
The DW367 has a bevel stop at 45 degrees. To set the bevel at an
angle greater than 45 degrees, tilt the shoe to 45 degrees, then slide
the knob and bolt into the upper slot. When you reach the desired
angle, tighten the knob.
The DW368 and DW369 are equipped with a bevel detent feature.
As you tilt the shoe you will hear a click and feel the shoe stop at both
22.5 and 45 degrees. If either of these is the desired angle, retighten
the lever (L) by lowering it. If you desire another angle, continue
tilting the shoe until the pointer aligns with the desired mark.
FIG. 9
1/4"
6.35 mm
Kerf Indicator (Fig. 9)
The front of the saw shoe has a kerf indicator for vertical and bevel
cutting. This indicator enables you to guide the saw along cutting
lines penciled on the material being cut. The indicator lines up with
the left (inner) side of the saw blade, which makes the slot or "kerf"
cut by the moving blade fall to the right of the indicator. The ribs
on the front of the DW368 and DW369 shoe are at 1/4" (6.35 mm)
spacing. The notches on the front of the shoe are at 1/2" (13 mm)
intervals.
OPERATION
WARNING: To reduce the risk of serious personal injury,
turn tool off and disconnect tool from power source before
making any adjustments or removing/installing attachments or
accessories.
Switch (Fig. 1)
Pull the trigger switch (B) to turn the motor on. Releasing the trigger
turns the motor off. This tool has no provision to lock the switch in the
on position, and the tool should never be locked on in any way.
9
1/2"
45˚
0˚
13 mm
Publicidad
