Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING: Always use eye protection. All users and
bystanders must wear eye protection that conforms to ANSI Z87.1.
• The label on your tool may include the following symbols. The
symbols and their definitions are as follows:
V .......... volts
Hz ........ hertz
min ...... minutes
... direct current
........ Class I Construction n o ........ no load speed
............
............
(grounded)
........ Class II Construction
............
(double insulated)
.../min . per minute
IPM ...... impacts per minute
SAVE THESE INSTRUCTIONS
FOR FUTURE USE
ASSEMBLY AND ADJUSTMENTS
WARNING: To reduce the risk of injury, turn unit off and
disconnect tool from power source before installing and
removing accessories, before making any adjustments or
removing/installing attachments or accessories. An accidental
start-up can cause injury.
A .......... amperes
W......... watts
....... alternating current
....... alternating or direct current
........ earthing terminal
......... safety alert symbol
BPM .... beats per minute
RPM .... revolutions per minute
sfpm .... surface feet per minute
Side Handle (Fig. 1)
WARNING: To reduce the risk of
personal injury, ALWAYS operate
the tool with the side handle properly
installed. Failure to do so may result
in the side handle slipping during tool
operation and subsequent loss of
control. Hold tool with both hands to
maximize control.
A side handle is supplied with this
hammerdrill. It clamps to the front of
the gear case as shown in Figure 1
and can be rotated 360˚ for right- or left- hand use.
Switch (Fig. 2)
WARNING: Be sure to release the locking mechanism before
disconnecting the plug from the power supply. Failure to do so will
cause the hammerdrill to start immediately the next time it is plugged
in. Damage or personal injury could result.
To start hammerdrill, depress the trigger switch. To stop hammerdrill,
release the trigger switch.
To lock the trigger switch in the ON position for continuous operation,
depress the trigger switch and push up the locking button. The tool
will continue to run. To turn the tool OFF, from a locked-on condition,
squeeze and release the trigger once. Before using the tool (each
time), be sure that the locking button release mechanism is working
freely.
DO NOT lock the switch on when drilling by hand so that you can
instantly release the trigger switch if the bit binds in the hole. The
locking button is for use ONLY when the hammerdrill is mounted in a
drill press stand or other wise held stationary.
15
FIG. 1
Publicidad
