Bollhoff RIVKLE P3007 Manual De Uso página 34

VI. Diagnosis and recommendations in case of breakdown
Before performing any operation, check the oil level and air supply pressure (between 5 and 7 bar)
PROBLEM
Thread of the pulling rod
damaged.
Difficulty screwing and
unscrewing.
RIVKLE ® tapping faulty
after setting.
The RIVKLE ® rotates
in its housing.
The tool is not unscrewing after
the end of the setting travel
Screwing does not work.
The setting stroke is zero.
The tool screws continuously.
Unscrewing does not occur (took
stuck on the part).
The tool takes some time to
unscrew after the end of setting.
PROBABLE CAUSE
Table 6
SOLUTION