Sun Microsystems GDM-5410 Manual página 3

Precautions
Warning on power connections
Use an appropriate power cord for your local power supply.
115 Volts 230 Volts
(not provided on
standard cord set)
United States, Continental
Canada, Europe
Taiwan,
Korea, Japan
Plug Type Plug Type
NEMA S-15P CEE7/VII
(Schuko)
Cord Type Cord Type
SJT HAR(HO5VV
-F3G1.0)
Min. cord set Min. cord set
rating rating
10 A/125 V 10 A/250 V
18/3AWG
Cord Length Cord Length
(+/– 0.1 m) (+/– 0.1 m)
2 m 2.5 m
Safety Safety
Approval Approval
UL/CSA HAR
Autoranging universal power supply works anywhere; the
monitor self-adjusts if the appropriate power cord and plug for
the local voltage are used.
• Before disconnecting the power cord, wait at least 30 seconds
after turning off the power to allow the static electricity on the
screen's surface to discharge.
• After the power is turned on, the screen is demagnetized
(degaussed) for about 2 seconds. This generates a strong
magnetic field around the screen which may affect data stored
on magnetic tapes and disks placed near the monitor. Be sure to
keep magnetic recording equipment, tapes, and disks away
from the monitor.
The equipment should be installed near an easily accessible
outlet.
4
CEE-22 cord set,
female end (all
power cord sets)
United Australia,
Kingdom, New Zealand
Ireland
Plug Type Plug Type
B S 1363 SAA AS 3112
Cord Type Cord Type
HAR(HO5VV CDB03PLP
-F3G1.0)
Min. cord set Min. cord set
rating rating
10 A/250 V 10 A/250 V
Cord Length Cord Length
(+/– 0.1 m) (+/– 0.1 m)
2.5 m 2.5 m
Safety Safety
Approval Approval
BSI, ASTA Dept. of
Energy of
New South
Wales
Installation
Do not install the monitor in the following places:
• on surfaces (rugs, blankets, etc.) or near materials (curtains,
draperies, etc.) that may block the ventilation holes
• near heat sources such as radiators or air ducts, or in a place
subject to direct sunlight
• in a place subject to severe temperature changes
• in a place subject to mechanical vibration or shock
• on an unstable surface
• near equipment which generates magnetism, such as a
transformer or high voltage power lines
• near or on an electrically charged metal surface
Maintenance
• Clean the screen with a soft cloth. If you use a glass cleaning
liquid, do not use any type of cleaner containing an anti-static
solution or similar additive as this may scratch the screen's
coating.
• Do not rub, touch, or tap the surface of the screen with sharp or
abrasive items such as a ballpoint pen or screwdriver. This type
of contact may result in a scratched picture tube.
• Clean the cabinet, panel and controls with a soft cloth lightly
moistened with a mild detergent solution. Do not use any type
of abrasive pad, scouring powder or solvent, such as alcohol or
benzene.
Transportation
When you transport this monitor for repair or shipment, use the
original carton and packing materials.
Do not lift this monitor by grasping the rear cover as shown
below, as the rear cover may come off.
Use of the tilt-swivel
This monitor can be adjusted within the angles shown below. To
turn the monitor vertically or horizontally, hold it at the bottom
with both hands.
90°
15°
5°
90°