Makita BO6030 Manual De Instrucciones página 5

10000
4000
B
A
1 2 3
Dial setting
003734
NOTE:
The figure shows standard applications. They may
•
differ under certain conditions.
A range: For polishing
B range: For finish sanding
C range: For regular sanding
CAUTION:
If the tool is operated continuously at low speeds
•
for a long time, the motor will get overloaded and
heated up.
The speed adjusting dial can be turned only as far
•
as 5 and back to 1. Do not force it past 5 or 1, or the
speed adjusting function may no longer work.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before carrying out any work on the tool.
Front grip
1
2
3
4
003738
Install the front grip on the tool so that its protrusions fit
into the matching notches in the front of the tool. Secure
the front grip using a screwdriver to tighten the screw
through the hole in the front grip.
C
4 5
1. Notches
2. Front grip
3. Hole in front grip
4. Screwdriver
Installing or removing abrasive disc
1
003739
CAUTION:
Always use hook-and-loop system abrasive discs.
•
Never use pressure-sensitive abrasive discs.
To install the abrasive disc, first remove all dirt or foreign
matter from the pad. Then attach the abrasive disc to the
pad, using the hook-and-loop system of the abrasive disc
and the pad. Be careful to align the holes in the abrasive
disc with those in the pad.
To remove the disc from the pad, just pull up from its
edge.
Changing pad
2
3
003740
Makita offers an extensive range of optional pads.
Remove the screw counterclockwise from the center of
the base with a hex wrench. After changing the pad,
tighten the screw clockwise securely.
Installing dust bag
1
003741
Install the dust bag on the tool so that the arrow with "UP"
indicated on the dust nozzle points upward.
5
1. Abrasive disc
1. Hex wrench
1
2. Screw
3. Pad
1. Dust nozzle
2. Dust bag
2