Publicidad
10 | English
The battery is supplied partially charged. To ensure full
battery capacity, completely charge the battery in the
battery charger before using for the first time.
Before any work on the machine (e. g., maintenance,
tool change, etc.) as well as during transport and stor-
age, set the rotational direction switch to the centre
position. Unintentional actuation of the On/Off switch can
lead to injuries.
Read the operating instructions of the battery charger.
Apply the power tool to the screw only when it is
switched off. Rotating tool inserts can slip off.
Adjust the gear switch only when the machine is at a
complete stop.
Always push the gear selector through to the stop. Oth-
erwise, the machine can become damaged.
If the gear switch cannot be pushed through to the
stop, turn the chuck slightly (GSR 10.8 V-EC).
The battery charge-control indicator consists of three
green LEDs, and indicates the charge condition of the bat-
tery for a few seconds when the On/Off switch is pressed
halfway or fully.
LED
Continuous lighting 3 x green
Continuous lighting 2 x green
Continuous lighting 1 x green
Flashing light 1 x green
To save energy, only switch the power tool on when using
it.
Symbols
The following symbols are important for reading and under-
standing the operating instructions. Please take note of the
symbols and their meaning. The correct interpretation of the
symbols will help you to use the machine in a better and safer
manner.
Symbol
Meaning
GSR 10,8 V-EC/GSR 10,8 V-EC HX:
Cordless Screwdriver
Grey-marked area: Handle
(insulated gripping surface)
Article number
Read all safety warnings and all instruc-
tions
Before any work on the machine itself,
remove the battery
2 609 141 137 | (4.12.13)
Symbol
Capacity
≥ 2/3
≥1/3
< 1/3
Reserve
U
n
1
0
n
2
0
M
Ø
Ø
*
L
wA
L
pA
K
a
h
Meaning
Always wear ear protection.
Movement direction
Reaction direction
Right/left rotation
Screwdriving
Drilling
Low speed
High speed
Switching On
Switching Off
Battery Charge Indicator
Rated voltage
No-load speed (1. gear)
No-load speed (2. gear)
Maximum torque according to ISO 5393
Metal
Wood
Drilling diameter, max.
Max. screw dia.
Tool holder
Chuck clamping range
Weight according to EPTA-Procedure
01/2003
Value dependent of the battery pack
being used
Sound power level
Sound pressure level
Uncertainty
Vibration total value
Bosch Power Tools
Publicidad
