Fenton 102.164 Manual De Instrucciones página 5

OPERATION
1. Connect the record player with the power adapter and plug the other end into a wall power outlet.
2. Remove the white protective needle cover by gently pulling towards the front of the unit.
3. Turn the power & volume control knob clockwise to turn on the record player.
4. Place a vinyl record on the turntable platter and select the desired speed (33/45/78RPM)
according to the record.
5. Open the tone arm clip to release the tone arm. Push the lift lever(it sits beside the auto stop
switch) backwards to raise the tone arm and gently move the tone arm to the desired position
over the record. You can turn the pitch control knob to adjust the speed of the platter little by little.
The turntable will begin to spin when the tonearm is moved toward the record(when the AUTO STOP switch is ON).
Push the lift lever forwards to lower the tone arm slowly onto the desired position on the record to start playback.
6. Turn the volume control knob to adjust the volume.
Noted: If the AUTO STOP ON/OFF Switch is turned ON, the record will stop automatically when finished. If Auto Stop Control is
turned OFF, record will NOT stop automatically when finished.
BT CONNECTION
''BT IN'' Function
Turn the function knob to BT mode. The LED indicator will flash in blue color.
Turn on the BT-function on your mobile phone or tablet PC on and then search the turntable player (Fenton recordplayer). After
pairing, the LED will light up continuously in blue color and you can play your music on your mobile phone or tablet PC on this
turntable player. Turn the volume control to adjust the volume. (The volume control of the mobile phone, tablet or PC can also
affect the total volume).
''BT OUT'' Function
If you want to connect another BT speaker to your record player to listen to the music on your record player, put your BT
speaker in BT mode and press button 13 on the record player. Then the LED light on the record player will start flashing and the
BT speaker will be connected. Once the connection is established, the LED light on the record player will stop flashing.
Note: When you connect to a BT speaker for the first time, it can take up to 60 seconds for them to connect. And the ''BT OUT''
function only works on the ''PH'' and ''AUX'' Mode
USB
To play music from a USB drive: Turn the mode selection knob to USB and plug in a USB drive to play music.
Press PLAY/PAUSE/REC to play or pause. Press PREV button to play the previous track, press NEXT button to play the next
track.
To record from vinyl: Plug your USB stick into the USB port. Press the REC button during the vinyl records playback and the
indicator will flash red and blue intermittently. The vinyl recording starts.
Press the SPLIT button when recording, the current record will be cut off and automatically stored in a file. Press SPLIT button
again and it will generate another file. Press the REC button to stop the recording. The indicator will be red during recording,
and the recorded files(MP3 format) will be saved in the USB stick.
AUX INPUT MODE
Connect your MP3 player, mobile phones, etc. to the AUX IN port with a 3.5mm-3.5mm audio cable (not included).
Turn the mode selection knob to AUX, you can now play music from an auxiliary device through the unit.
Turn the VOLUME CONTROL KNOB to adjust the volume (the connected devices' volume control may also have impact on the
record player output volume level so ensure this is also turned up accordingly).
RCA OUTPUT MODE
Connect your own speaker system to the RCA port of the record player with an RCA-3.5mm audio cable (not included).
NOTE: the RCA cables are color coded. The red plug cable must be plugged into the red jack on both the record player and
external amplifier or speaker system. The white plug cable must be plugged into the white jack on both the record player and
external amplifier or speaker system.
5