King Tony 9TYE13110AB Manual De Instrucciones página 4

WARNING!!
1. This is a lifting device ONL Y. Do not move or dolly the vehicle while on the jack.
2. Position this jack to ONLY lift on the areas of the vehicle as specified by the vehicle
manufacturer.
3. After lifting the vehicle, ALWAYS support the load with appropriately rated vehicle support
stands BEFORE working on the vehicle.
4. Do not overload this jack beyond its rated capacity. Overloading can cause damage to or
failure of the jack.
5. This jack is designed ONL Y for use on hard level surfaces capable of sustaining the load. Use
on other than hard level surfaces can result in jack instability and possible loss of load.
6. Center load on jack saddle BEFORE lifting vehicle. Off-center loads and loads lifted when the
jack is not level can cause loss of load or damage to the jack.
7. Study, understand and follow all instructions in this manual BEFORE operating the jack.
8. Failure to read these warnings may result in loss of load, damage to the jack and/or jack
failure resulting in personnal injury or proparty damage.
OPERATING INSTRUCTIONS
Important: Sometimes during shipment and handling, air gets into the hydraulic system,
causing poor lifting performance. Before initial operation, purge any air from the system by fully
opening release (Turn handle knob(3-8) counter-clockwise). Then, while holding the saddle
down, pump pedal(3-2) rapidly several times.
Raising jack
1. Turn handle knob(3-8) clockwise until resistance is felt to close release valve. Do not over-
tighten.
2. Place jack directly under abject to be lifted. Make sure saddle takes up weight firmly and
centrally. Check positioning under slight load to confirm jack or load will not slip.
3. Raise jack by pumping handle until desired height is reached. After lifting, secure load by
appropriate means. Do not use jack as the only means of support.
Lowering jack
1. Slowly turn the handle knob (3-8) counterclockwise. The descent speed is faster or slower
depending on how fast you turn the handle.
Read this manual and follow all safety rules and
operating instructions before using this product.