Publicidad
Hardware Usage Guide
HOW TO USE A TWIST-LOCK
1.
Push a TWIST-LOCK® FASTENER
into the large hole in the part.
Step 2
å
Using your hammer, gently tap four LEVELERS (46E)
completely into the holes in the ENDS (A and B).
å
NOTE: Adjustments to the LEVELERS will be made later in
assembly once your unit is standing upright.
å
Insert four WOOD DOWELS (42F) into
the ENDS (A and B).
å
NOTE: You may need to gently tap the WOOD
DOWELS in with your hammer.
å
NOTE: The SMALL END (C) is not used in
this assembly.
Edge with TWIST-LOCK® FASTENERS
www.sauder.com/commercial-office/service
FASTENER
®
2.
1. Insert the dowel end of the FASTENER into the
hole of the adjoining part.
NOTE: The dowel end of the FASTENER must
remain fully inserted in the hole of the adjoining
part while locking the FASTENER.
2. Tighten the FASTENER with a Phillips
screwdriver as tight as possible.
(4 used)
42F
B
426274
Dowel end
2
A
46E
(4 used)
Page 7
Publicidad
