Publicidad
Step 7
å
We have provided a Nail Holder tool to use in this step for proper positioning of the NAILS. Please refer to the parts of the
Nail Holder as the bead, offset edge, and nail slot as shown in the diagram below.
å
Diagram 1. Place the BACK (E) into the lower edge of the RIGHT END (A) with the top edge of the BACK (E) against the
lower edge of the TOP (F).
å
Diagram 2. Place the bead of the Nail Holder down between the BACK (E) and LEFT END (B) 2" from the corner. Place
a NAIL (1N) into the nail slot of the Nail Holder. Tap the NAIL through the BACK and into lower edge of the LEFT END.
Remove the Nail Holder from the NAIL and completely tap the NAIL in with your hammer. Finish fastening the BACK to
the LEFT END with the hammer and Nail Holder placing NAILS approximately 5" apart.
å
Repeat this step to fasten the BACK (E) to the RIGHT END (A).
å
Diagram 3. Fasten the BACK (E) to the BOTTOM (C) using the NAILS (1N) and Nail Holder. The NAILS should be 1" from the
corners and 5" apart.
å
Repeat this step to fasten the BACK (E) to the TOP (F).
Offset edge
Nail
Holder
Bead
F
1.
Lower edge
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
www.sauder.com/commercial-office/service
These holes must
line up over the
FIXED SHELF (G).
Nail slot
A
2.
2"
5"
Bead
Bead
B
E
427450
1N
NAIL
(42 used in this step)
1"
3.
5"
Bead
Bead
C
Page 11
Publicidad
