Publicidad
Idiomas disponibles
Idiomas disponibles
Testing torque wrenches
Testing indicating torque wrenches
In the case of indicating torque wrenches, the operator must stop the
tightening procedure on reaching the set torque.
To test an indicating torque wrench, proceed as follows:
➢ Switch the DPG on, see Page 74.
➢ To set Peak Hold mode, see Page 74.
➢ Connect the torque wrench to be tested to the DPG, see Page 83.
➢ Actuate the connected torque wrench slowly and evenly in the
desired direction of rotation and monitor the value shown on the
DPG's display.
➢ Check whether the values indicated by the torque wrench match
those on the DPG's display.
➢ To save the test value, press the Clear button or start a new
tightening process for automatic saving.
86
Publicidad
