Publicidad
Idiomas disponibles
Idiomas disponibles
Preparation of coffee/tea/drinks
• When the led (2) turns on, the coffee machine is ready for use (Fig. 8).
•Use only capsules that are specific for this model.
•Place a cup under the dispenser
•Slowly lift the control lever (1) back (until it stops) and introduce a capsule in the slot provided
(Fig. 9).
IMPORTANT:
Before inserting the capsule, slowly lift the control lever (1) located on
the top of the machine.
For correct hygiene it is advisable to eject the capsule immediately
after dispensing: to do this, completely open the lever (1) as far as
it will go
• Fully lower the lever (1) and press button (3) until the desired quantity has been released, then
press button (3) again to stop (Fig. 10).
Mod. OFFICE PLUS Mod.OFFICE PLUS VAP: Press either the large cup
dispenser button depending on personal taste.
•Repeat the steps above for additional cups of coffee/tea using a new capsule for each drink.
• To fully remove the capsule, slowly lift the lever (1). If the capsule does not come out, repeat
the procedure or press the start button (3) while simultaneously lifting the lever (1).
USEFUL TIP:
• Use thick cups when preparing Espresso and try to heat them beforehand. This will keep your
coffee warm for longer.Cups can be heated under hot running water.
2
Fig. 8
1
Fig. 9
25
reject
(D) or small cup
3
Fig. 10
open
(E)
1
Publicidad
