Activate Acoustic Signals (Beep); Restore Factory Settings (Rset) - Seca 264 Manual De Instrucciones Y Garantía

Activate acoustic
signals (bEEP)
Restore factory settings
5. To change the setting or to call up another
submenu, keep pressing the arrow key (hold/zero)
until the required setting (here: display brightness
"bri") is displayed.
6. Confirm your selection with the Enter key (send/
print).
The current setting for the menu item or a submenu
is displayed (here: "display brightness 50%").
7. To change the setting or to call up another
submenu, keep pressing the arrow key (hold/zero)
until the required setting (here: display brightness
"100 %") is displayed.
8. Confirm the setting with the Enter key (send/print).
You will leave the menu automatically.
9. To make further selections, call up the menu again
and proceed as described above.
NOTE
If no key is pressed for approx. 24 seconds, the
menu is automatically quit.
You can set the head slide so that an acoustic signal
sounds each time a key is pressed.
1. Select the item "bEEP" from the menu.
2. Confirm the selection.
The current setting is displayed.
3. Select the setting you require:
– On
– Off
4. Confirm your selection.
You will leave the menu automatically.
You can restore factory settings to cancel settings you
(rSEt) have made.
Acoustic signal
Display backlighting brightness 50%
Display backlighting duration
Wireless module (SYS)
Autosend (Asend)
Function
Operate head slide • 63
English
Factory setting
on
Short
off
off