LUCCI AIRFUSION CLIMATE Manual De Instrucciones página 13

Airfusion Climate Installation Instructions
Re-configure the factory default DIP switches setting in the remote so that the receiver and remote
D.
(transmitter) communication is on a different channel. The four DIP switches can be set in any (up or
down) resting position with an aid of a pen tip or small screw driver as shown below.
E. Please repeat the (A)-(C) steps to check the function.
F. If the issues still persist after following point (A) to (D) and there is still no control, then please contact the local
retailer for a new remote or transmitter.
NOTE: For your safety, a new receiver must be installed by a licensed electrician.
NOTE: While repairing the DC ceiling fan remote and receiver is in progress, the fan automatically operates at
highest speed in REVERSE mode for approximately 2 minutes and then operates in FORWARD mode for another
2 minutes. During the paring process, do not press any button on the remote.
Please note that not all ceiling fans are the same, even in the same model—some may move more or less than others.
Movement of a couple of centimetres is quite acceptable and does not suggest that the fan will fall down.
Even though all blades are weighted and grouped by weight, it is impossible to eliminate wobble altogether. This should
not be considered a fault. Ceiling fans tend to move during operation due to the fact that they are not generally rigidly
mounted.
You may take the following action to reduce the wobbling:
1) Check all the blade mounting screws are tightened and secure.
2) Wobbling problems may result from inconsistent blade levels. To check blade levels, measure the distance from each
12 | P a g e
BALANCING/WOBBLYING TROUBLE SHOOTING