LUCCI AIRFUSION CLIMATE Manual De Instrucciones página 14

Airfusion Climate Installation Instructions
blade tip to the ceiling.
Note: If measurements are inconsistent:
- Check that the blade mount screws are not over tightened or loose, which can cause the blade tip to not sit level;
- An out of shape blade can cause wobbling, check by removing the blade and lay it on a flat surface. A good flat
blade will lay flat on the surface.
3) Blade tracking may be checked simply by use of a household ruler as shown in the below figure. Place the ruler
vertically against the ceiling and even with
the outside leading edge of a blade. Note
the distance of the edge of a blade is the
same as the others. Turn the blade slowly
by hand to check the remaining blades. If a
blade is not in alignment, the blade is either
out of shape/warped or the blade screws
are not evenly tightened or loose.
BALANCING KIT
1.
A balancing kit is provided to balance the ceiling fan on initial installation. Please refer to the instruction on how to
use the balancing kit that is included.
2.
The balancing kit can be used to assist re-balancing if the ceiling fan becomes un-balanced overtime. Do not discard
the balancing kit, retain for future use.
Always check the "Trouble Shooting Checklist" included in this booklet before calling for service. Unnecessary calls are
inconvenient for all and can attract a service charge.
For your safety, ensure the ceiling fan is OFF before carrying out any troubleshooting.
TROUBLE
A. Fuse or circuit breaker blown.
1. Fan will not start. B. Loose power connections to the
fan.
(Warning: The ceiling
fan must be switched installation.)
OFF and the assistance
C. No response from the remote
of a licensed electrician
transmitter.
may be required.)
D. Switch the fan ON via the mains
switch.
A. Fan blades are not horizontal to
the ceiling.
2. Fan wobbles.
(Refer to the Wobble
section in this manual
for further information.)
B. Blade screws are loose.
C. Blade/s are out of shape.
13 | P a g e
TROUBLE-SHOOTING CHECKLIST
PROBABLE CAUSES
(Normally occur's during
SUGGESTED REMEDY
Check main and branch circuit fuses or
breakers.
Check power connection to the fan. This must be
performed be a licensed electrician.
- Battery is low. Replace batteries.
- Check if correct remote transmitter is paired with
the receiver.
Check if there is power to the fan.
Refer to "wobble" section in this manual.
- The blade may require adjustment at the
blade mounting screws.
- The blade is out of shape, thus causing
wobbling. A new blade set will be required to
be replaced. Contact retailer for further
details.
Make sure all screws are securely fastened.
Remove the blades and lay on a flat surface to check
if they are out of shape. Contact retailer for further
circuit