Assembly Of The Bed - Invacare Medley Ergo Manual Del Usuario

2.2 Assembly of the bed

For questions concerning the assembly of your bed please
contact your dealer or Invacare customer service.
Mattress Support
1. Push the foot end of the mattress support onto the head frame.
2. Tighten with two thumb screws.
3. Turn the four mattress handles of the backrest and footrest up.
4. Turn the locking ring* on the bed ends to the position "open"
5. Latch the mattress support to the bed ends and press firmly into
position**.
6. Make sure that the bed ends are in the same level. It is possible to
level the bed in high position (A) and low position (B).
7. Turn the locking ring to the position "lock". Always put locking ring
in the upper slot as shown in pictures
* The locking rings locks ensure that the mattress support is not
accidentally lifted clear of the bed ends.
** It is normal to have a small space between the top of the slot on the
mattress hook and the bracket on the bed end.
Rastofix
1.
1. & 2. Press bottom of Rastofix at the foot end of the bed
2. 3.
3. Squeeze upper end of Rastofix together
10
4.
4. Rotate Rastofix between tabs and
release
Space
Bracket
Hook