Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
Installation instructions
We recommend that a qualified technician install the
hood. It is the installer's responsibility to ensure the hood
complies with the installation clearances specified for the
product.
•
It is recommended that the vent system be installed
before the hood is installed.
•
If possible, disconnect and remove any cooking
appliance from beneath the hood area to provide
easier access to the rear wall.
•
Before making cutouts, make sure there is proper
clearance within the ceiling or wall for the exhaust
vent.
Stainless steel hood spacer installation
•
You can elongate 1.5" (3.8 cm) of your hood width (¾"
[1.9 cm] per side), installing the stainless steel spacers
included with your hood.
•
Unpack the spacer and take off the protective film.
•
Put each one on the right and the left side
•
Fasten hood spacers to the hood cabinet and tighten
securely using 3 - 3.5 x 6.5 mm screws each.
12
ENGLISH
•
1.
2. Determine which venting method to use: roof or wall
3. Select a flat surface for assembling the hood. Place a
•
•
Side spacer
Confirm that all installation parts have been removed
from the shipping carton.
Turn off the power at the circuit breaker panel or fuse
box.
exhaust.
NOTE
This hood is factory set to vent through the top air exit.
covering over that surface
If cabinetry designs reduces the width opening (i.e. –
28.5", 34.5" or 46.5") to install the hood, the spacers
are not used.
If you have a full width opening (i.e. – 30", 36" or 48")
to install the hood, you should use the spacers.
Publicidad
