Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
Prepare the location
•
Disconnect power.
•
Determine which venting method to use: roof or wall
exhaust.
•
Select a flat surface for assembling the hood insert.
Place covering over that surface.
•
It is recommended that the vent system be installed
before hood is installed.
•
Before making cutouts, make sure there is proper
clearance within the ceiling or wall for exhaust vent.
Install hood into hood cabinet
The hood attaches to the hood cabinet using 4 - 5 x 45
mm screws and washers.
NOTE
Hood cabinet must be capable of supporting 75 lb (34 kg).
Prepare hood for mounting into cabinet
1.
Mark the locations for the four mounting screws on
the hood cabinet as shown below.
2. Using a ⅛" (3 mm) drill bit, drill the 4 holes.
Mounting hole dimensions
DIM
Model
A
30"
6"
(15.5
cm)
36"
48"
Wall
A
B
C
D
DIM
DIM C
DIM D
B
12⁵⁄₃₂"
24⁵⁄₁₆"
(30.9
(61.8
10¹⁄₁₆"
cm)
cm)
(25.7
cm)
29¹³⁄₁₆"
14¹⁵⁄₁₆"
(75.7
(37.8)
cm)
•
Hood insert should be installed a minimum
24" (60.9 cm) above an electric cooking product
and 30" (76.2 cm) above a gas cooking product. The
maximum recommended height over both cook tops
is 36" (91.4 cm).
•
Check that all installation parts have been removed
from the shipping carton.
•
Using 2 or more people, lift hood insert onto covered
surface.
•
Remove the filters. See the "Cleaning" section.
3. Mark the cutout for the rectangular clearance hole for
the upper hood motor housing as shown.
4. Using a jigsaw, cut out the rectangular clearance hole
for the upper hood housing.
Upperhood motor housing dimensions
Model
30"
36"
48"
DIM E
Ø ¹⁄₈"
(3mm)
Wall
C
D
DIM A
DIM B
DIM C
(28 cm)
4 ⁴/₅"
12 ⁷/₁₆"
(12.2 cm)
(31.4 cm)
(35 cm)
A
B
DIM D
11"
22" (56
cm)
13 ⁷⁄₁₀"
27⁹⁄₁₆" (70
cm)
ENGLISH
13
Publicidad
