BELLOTA HL1100 Manual Del Usuario página 27

(Not included)
• Align the ridge on the handle with the notch on
the left side. Insert the handle to socket of
the right transport handle. Pull out the handle
before usage (C).
(C)
To attach the pressure hose to the pressure
washer locate the connecting port on the back
of the cleaner. Press the latch towards the hole
and insert the metal connector of the high
pressure hose (D). Release the latch to lock the
hose in place. An alternative method of hose
insertion is to firmly press the hose connector
into the connecting port without pressing the
latch until it clicks into place securing it.
After the hose is attached, check the connection
by gently pulling upon the hose. It should not
pull out. (D).
(D)
When not in use the trigger gun may be stored
in the snap on accessory latch or back of the
machine
(B)
HL2400PRO
After unpacking your pressure washer, lay out
the parts and accessories on a flat surface
and familiarize yourself with the parts in the
package by comparing them to those on
page 15. If you find any parts are missing or
damaged, do not use the product and contact
contact your dealer. The use of incomplete or
damaged products may present a danger to
people and property. NOTE: Some parts may or
may not already be assembled.
Accessories not included: 1 Phillips screwdriver
• Attach the handle to the back of your pressure
washer by lining up the holes in the handle with
the pins on the machine (A). Slide it in and
secure with the supplied screws (B).
• Push the handle (C) into the opening of the
spool (D), • make sure it clicks into place.
23
(A)
(B)
(D)
(C)