BELLOTA HL1100 Manual Del Usuario página 33

9. Troubleshooting
Problem Posible cause
• Pressure washer is not connected.
• Faulty power supply.
The pressure washer
• Defective extension cable.
is not starting.
• The pump is drawing in air.
• Dirty, worn, or stuck valves.
• Worn pump seals.
Pressure is not
constant.
• Incorrect power supply.
• Thermal sensor is activated.
The pressure washer
• Nozzle partially blocked.
stops while working.
• Air in the hose.
• Wrong water supply.
The pressure washer
• Nozzle partially blocked.
is pulsating.
• Air filter blocked.
• Tangled hose.
• Frozen pump, hoses
or accessories.
The pressure washer
• No water supplies.
starts but no water
• The water filter is blocked.
comes out.
• The nozzle is blocked.
NOTA: Bellota reserves the right to make changes to machines and manuals without notice.
Solution
• Connect the pressure washer.
• Use a different power supply.
• Replace the extension cable.
• Check the hoses and connections
have no leaks.
• Clean the dirty parts and replace
the worn ones.
• Go to an Authorized Service
Center if
the problem still persists.
• Turn OFF other machines.
Check the voltage supply is
matching the specified voltage
specified in this instruction.
• Allow the pressure washer to
cool down.
• Clean the nozzle.
• Run the pressure washer with
the trigger open until it runs
regularly and pressure restarts.
• Check the water supply meets
the required specifications.
Avoid using long and thin hoses.
Minimum ½".
• Clean the nozzle.
• Clean the filter.
• Straighten the hose.
• Wait for the thawing of the pump,
hoses or accessories.
• Connect the water input.
• Clean the filter.
• Clean the nozzle.
29