Forch 5331 1 18 1 Manual Original página 15

bend causing breakage or loss of control, result-
ing in personal injury.
Additional safety warnings
Switch the power tool off immediately if the
u
application tool becomes blocked. Be pre-
pared for high torque reactions which cause
kickback. The application tool becomes
blocked when it becomes jammed in the work-
piece or when the power tool becomes over-
loaded.
Hold the power tool securely. When tighten-
u
ing and loosening screws be prepared for tem-
porarily high torque reactions.
Secure the workpiece. A workpiece clamped
u
with clamping devices or in a vice is held more
secure than by hand.
Use suitable detectors to determine if there
u
are hidden supply lines or contact the local
utility company for assistance. Contact with
electric cables can cause fire and electric shock.
Damaging gas lines can lead to explosion.
Breaking water pipes causes property damage.
Always wait until the power tool has come to
u
a complete stop before placing it down. The
application tool can jam and cause you to lose
control of the power tool.
In case of damage and improper use of the
u
battery, vapours may be emitted. The battery
can set alight or explode. Ensure the area is
well ventilated and seek medical attention
should you experience any adverse effects. The
vapours may irritate the respiratory system.
Do not open the battery. There is a risk of
u
short-circuiting.
The battery can be damaged by pointed ob-
u
jects such as nails or screwdrivers or by
force applied externally. An internal short cir-
cuit may occur, causing the battery to burn,
smoke, explode or overheat.
Only use the battery with products from the
u
manufacturer. This is the only way in which you
can protect the battery against dangerous over-
load.
Protect the battery against heat, e.g.
against continuous intense sunlight,
fire, dirt, water and moisture. There is
a risk of explosion and short-circuiting.
1 609 92A 7MF • 25.11.22
Product Description and
Specifications
English
Please observe the illustrations at the beginning of
this operating manual.
Intended use
The power tool is intended for driving and loosen-
ing screws and for drilling in wood, metal, ceramic
and plastic.
Product Features
The numbering of the product features refers to
the diagram of the power tool on the graphics
page.
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)
(10) On/off switch
(11) Handle (insulated gripping surface)
(12) Universal bit holder
(13) Carbon brushes
a) Accessories shown or described are not included
Technical data
Cordless Drill/Driver
Article number
Rated voltage
No-load speed
– First gear
– Second gear
Impact rate
English
Read all the safety and general in-
structions. Failure to observe the
safety and general instructions may
result in electric shock, fire and/or seri-
ous injury.
English
English
Tool holder
Keyless chuck
Torque presetting ring
Gear selector switch
Cover cap
Rechargeable battery a)
a)
Battery release button
Worklight
Rotational direction switch
a)
with the product as standard. You can find the com-
plete selection of accessories in our accessories
range.
English
A)
min
min
min
5331 1 18 1
V= 18
–1
0–480
–1 0–1800
–1 –
English | 15