Eschenbach elumentis LED Manual De Instrucciones página 8

Idiomas disponibles

Starting up

1. Set the desk lamp on a flat and stable surface.

2. Plug the angle plug of the supplied power supply unit into the socket t at the rear of the stand.

3. Insert the mains plug of the power supply unit into a properly wired electrical outlet.

4. Adjust the lamp head q and the lamp arm e according to your needs.

If the adjusted position of the lamp head or lamp arm is not maintained or is too stiff, adjust the head joint 

or the base joint r of the lamp arm accordingly.

5. Press the power button

normal.

6. You can adjust the brightness with the

the brightness in 5 steps. Short press

down the respective button, the brightness changes steplessly. The brightness is set separately for each color

temperature. The respectively set brightness is retained when the desk lamp is switched off and when the

color temperatures are switched.

Press the

button i repeatedly to cycle through the 3 available color temperatures:

2700K, for warm white light,

6400 K, for cool white light,

4800 K, for neutral white light.

7. The desk lamp offers you the use of an ambient light. With the

combinations of main and ambient light:

Main light on / ambient light off

Main light on / ambient light on

Main light off / ambient light on

8. To disconnect the unit from the mains power supply, unplug the power cord from the wall outlet.

9. If the lamp head is mainly used swiveled to the side, the holding force of the joint may weaken over time

and the lamp head may drop. In this case, the middle joint on the lamp head can be readjusted using the

setscrew d.

Care instructions

Unplug the desk lamp from the power supply before cleaning!

Clean the device with a damp cloth. Do not use soap solutions containing plasticisers, alcoholic solvents or abra-

sive cleaners!

s to turn the light on or off. A slight warming in the area of the glowing LEDs is

o and

a repeatedly to decrease the brightness in 5 steps. If you hold

a buttons. Short press

button u you can switch through three

- 8 -

o repeatedly to increase