Velleman DVR4L5 Guía Rápida página 6

• There is also an audio output connector. Connect an audio device e.g. a speaker to this connector
when desired. Connector type is BNC.
Connecting Local Area Network (LAN)
• Connect the DVR to a local network by plugging a network cable into the LAN port at the back of
the DVR. Connector type is 8P8C (RJ45). Setup is done through the OSD.
7. Preliminary settings
• Make sure the connected cameras are on and set the power switch at the rear of the device to the
on-position. It takes about 15 to 30 seconds to start up.
Menu overview
• Press the MENU button and enter the password to go into the menu list.
Note: default admin password is "0000" (4 times zero).
QUICK START
DATE SETUP
SYSTEM
EVENT
INFORMATION
ADVANCED
CONFIG
SCHEDULE
SETTING
For more details, refer to the full user manual.
Setting date and time
• Before using the DVR the time and date should be set to get a valid time stamp.
• Press the MENU button and enter the admin password to go into the menu list.
• Select the QUICK START menu item.
• Use the NAVIGATION button to move to the TIME SETUP menu item. Select it to set date and
time.
Note: once recording started, do not change date or time as this will make it very difficult to
find back the recorded files.
Note: when using the DVR for the first time and the correct time is set, leave it on for at
least 48 hours.
Password setting
• Press the MENU button and enter the password to go into the menu list.
• Select the SYSTEM menu item.
• Go to TOOLS. Select ADMIN PASSWORD (or OPERATOR PASSWORD) and press the ENTER button
to set the password.
Note: an operator can not access the main menu, only the quick menu bar (see below).
26/01/2010
DVR4L5
GENERAL - TIME SETUP
DATE INFO - DAYLIGHT
TOOLS - SYSTEM INFO
QUICK SEARCH - EVENT SEARCH - HDD INFO - EVENT LOG
CAMERA – DETECTION – ALERT – NETWORK – SNTP – DISPLAY –
RECORD - REMOTE
RECORD - DETECTION
6
Rev. 01
©Velleman nv