Publicidad
Idiomas disponibles
Idiomas disponibles
1
3
2
1
:
Loosen the clamp screws (1).
:
Push the gearbox (2) onto the drive
tube (3) – turn the gearbox back and
forth at the same time – until the end
of the drive can no longer be seen in
the slot in the clamp (arrows).
Continue pushing the gearbox as
far as stop.
:
Position the gearbox on the drive
tube so that the machine support on
the engine points down and the
blades are horizontal.
:
Tighten down the clamp screws
firmly.
HL 90 K
Adjusting the Throttle Cable
A properly adjusted throttle cable is
the precondition for correct
operation in the full throttle, starting
throttle and idle positions.
Adjust the throttle cable only after
the unit is fully assembled
:
Use a suitable tool to push the slide
to the bottom of the slot
English / USA
1
2
:
Press down the trigger interlock (1)
and squeeze the throttle trigger (2)
(full throttle) – this sets the throttle
cable correctly.
15
Publicidad
