INSTALLATION PROCEDURE - Spout
1. Remove nut, slip washer and bot t om gasket.
2. Install the spout on the countertop.
3. Install bottom gasket, slip washer
and nut in that order.
4. Confirm the alignment of spout and
tighten nut.
INSTALLATION PROCEDURE - Controller
1. Select the position of the controller
and layout the mounting template.
Make sure the sensor cable and soa p
tube can reach the mounting templ a te.
2. Mark the location of the mounting
holes.
3. Drill 3 holes.
Depth : 1" (25mm)
Size: 7/64" (3mm) without anchor
1/4" (7mm) with anchor
Important: Mounting template to be level.
Remove
Slip washer
Nut
Tube
Countertop
Slip washer
Nut
Tube
Mounting template
5
Top gasket
Bottom gasket
Slip washer
Nut
Countertop
Bottom gasket
Sensor cable
Bottom gasket
Sensor cable