Publicidad
Idiomas disponibles
Idiomas disponibles
Problem
The appliance does
House fuse is blown, circuit breaker has tripped, or power outage has occurred.
not heat.
• Reset circuit breaker or replace fuse. Do not increase fuse capacity. If the problem is a
Selected cycle does not use heat.
• Some cycles default to unheated or air drying. Select a cycle that allows heated drying.
Water leaks.
The water container hose or the optional drain hose is not connected correctly.
• Connect the water container hose or the optional drain hose correctly.
The door is closed while clothes or foreign substance is caught in the door.
• Check if clothes or foreign substance is caught in the door before using the appliance. If
The appliance runs
This is normal operation for the Wrinkle Care option.
and pauses by itself
• Check to see if the Wrinkle Care option has been selected. The option is designed to
after the drying cycle
finishes.
The control panel
The cool down stage is operating to cool down high internal temperature of the drum
time has stopped at
for customer safety.
1 minute.
• The cool down stage can run for up to 20 minutes depending on the internal temperature
Drying ended earlier
The clothes are dried according to the Dry level or Dry mode setting.
than the initial
• If the humidity or temperature in the drum reaches the product setting, the dry cycle may
control panel time.
Clothes take too long
Energy Saver option selected (on some models).
to dry.
• If using the Normal mode, deselect the Energy Saver mode. The Energy Saver mode
Performance
Problem
Clothes are wrinkled. Clothes dried too long (overdried).
• Over drying a load of laundry can lead to wrinkled clothes. Try a shorter drying time or use
Clothes left in dryer too long after cycle ends.
• Use the Wrinkle Care option. This option will tumble the clothes briefly every few minutes
Greasy or dirty spots
Fabric softener used incorrectly.
on clothes.
• Confirm and follow the instructions provided with your fabric softener.
Clean and dirty clothes are being dried together.
• Use your dryer to dry only clean items. Soil from dirty clothes can transfer to the clean
Clothes were not properly cleaned or rinsed before being placed in the dryer.
• Stains on dried clothes could be stains that were not removed during the washing process.
circuit overload, have it corrected by a qualified electrician.
water leaks continuously, contact the LG Electronics Customer Information Center.
prevent creases that are formed when the clothes are not unloaded promptly after the
drying cycle. When the option is set, the appliance runs for 10 seconds and pauses for 5
minutes. The option runs for up to 2 hours.
of the drum.
end earlier than the control panel time.
reduces energy use but takes longer to dry clothes than the Normal mode.
the lower dry level setting and remove items while they still retain a slight amount of
moisture.
for up to 2 hours to help prevent wrinkling.
clothes in the same or later loads.
Make sure that clothes are being completely cleaned or rinsed according to the
instructions for your washer and detergent. Some difficult soils may require pre-treating
prior to washing.
Possible Cause & Solution
Possible Cause & Solution
TROUBLESHOOTING
45
Publicidad
